Satin Nickel Oval Closet Rod End Brackets | Screw-on Type | 15mm x 30mm | 25 Pair

Think all oval end supports are the same? Think Again!These oval rod end supports are the finest quality out there... bar none! Take a close look at the photos and you'll see our trademark "D" that's embossed onto the surface. This means you're not getting some generic knockoff. You're getting a little “closet jewel” that was made with meticulous quality control.Fantastic FinishThis little work of art is made from cast metal. After cooling, it goes through a multi-step grinding/polishing process to remove burrs and other imperfections. We take as much time as needed during this phase of production, because it really sets the stage for the final finishing process, where we apply a generous nickel plating, and follow up by painstakingly hand buffing the piece to create the satin effect. Since this process is done entirely by hand, this is where we also practice quality control to ensure you're getting a flawless product.Installation OptionsUnlike our "rear-facing pin" end brackets, these have "flat backs", so you can install them over virtually any surface. We really went overboard with the screws department too, because we provide 2 different lengths. If you're going into a wood panel (and are concerned about the tip of the screw popping out the other side), use the short ones. For all other applications, use the longer ones. Got sheetrock? Yeah... we've got you covered there too! Just use the provided hollow wall anchors! Once the brackets are installed, just cut your oval rods to length, and you'll be hanging up clothes in no time flat!Very Important!These brackets are ONLY meant for OVAL rods! They will NOT work on ROUND rods!Here's what you get...- 2 Pairs of satin nickel oval rod end brackets (enough to hang 2 rods)- Matching ¾” screws- Matching 1 1/8" screwsHollow wall anchors

• OVAL RODS ONLY - Please note that this product is intended for 15mm x 30mm (+- 9/16" x 1 1/8") oval rods ONLY. It will NOT work on ROUND rods!
• A DESUNIA EXCLUSIVE – Don’t be fooled into thinking that all oval brackets are alike. When you see our signature “D” you know you’re getting something that’s quite unique and is guaranteed to fit all Desunia oval rods.
• AMAZING FINISH – Each bracket starts out as a single piece of zinc alloy, cast in our proprietary molds. Once cooled, they’re machined until they’re “baby’s bottom” smooth, and then receive a generous nickel plating. Finally, each piece is hand buffed with an abrasive wheel until the perfect satiny appearance is achieved. During packaging, all end brackets undergo strict quality control to ensure that perfection winds up in your closet!
• INSTALL THEM ANYWHERE – These oval brackets do NOT have 5mm rear pins, so they’re intended to be mounted on any smooth surface. For wood partitions, use the ¾” long screws. For drywall, use the longer screws and hollow wall anchors. Either way, we’ve got you covered!
• HERE’S WHAT YOU GET – 50 “screw-in” style wall brackets for an oval 15mm x 30mm (+- 9/16” x 1 1/8”) closet rod (enough to install 25 rods). 1 1/8" wood screws, ¾” wood screws, hollow wall anchors.